Amp assign on Denon 2113

[ankitbhargava]

Since I just have 5.1. I had been trying to use the SB channel amp for FS and this is the information I have got. Just confused if its must to run 2 set of wires as explained?

Any other suggestion?

++
FRONT A/B BI-AMP - Use this setting if you are running a 5.1 setup, and you would like to use the spare SB amps to bi-amplify your front speakers. Please note that you must have bi-amp capable speakers with FOUR speaker wire posts, and remember to remove the "jumper" connecting the posts or you will blow your amp!

In this setting, you will run one set of speaker wire from the FRONT L/R terminals on the Denon to the lower binding posts on your front speakers, and then a second set of speaker wire from the SURR.BACK terminals on the Denon to the upper terminals on your speakers.

++

 

[ankitbhargava]

Hi, anyone?
Still looking for help on this

 

[ankitbhargava]

Just bouncing off this thread trying to get some information.

 

[jagdish_p]

Following are the steps
1) Assign the AVR setting for Bi Amping
2) Remove the links between the two binding posts on the fronts
3) run two sets of parallel speaker cables from AVR to each speaker
4) connect one wire set to AVR fronts and other end to High frequency binding posts on speaker
5) connect the second speaker wire set to AVR rear surround and speaker LF binding posts

6) repeat above for the other front

 

[ankitbhargava]

Following are the steps
1) Assign the AVR setting for Bi Amping
2) Remove the links between the two binding posts on the fronts
3) run two sets of parallel speaker cables from AVR to each speaker
4) connect one wire set to AVR fronts and other end to High frequency binding posts on speaker
5) connect the second speaker wire set to AVR rear surround and speaker LF binding posts

6) repeat above for the other front

Thank you, did that last night and now system is Bi amped, perfoming much better!