Onkyo HTS3500
- Thread starter Pravz
- Start date
For the best speaker damping and least amount of power loss you will want to use the heaviest gauge that is practical. The length of the speaker wire should be considered when considering wire gauge. You will also want to consider the size of power amplifier you are using. The larger the amplifier, the heavier gauge you will want to use. Generally speaking, runs of 25 Ft or less work well with 14 gauge. Over 25 one should use 12 gauge if possible. These numbers are not set in stone, but generally work well.
baijuxavior
Well-Known Member
DAC cable available from hifimart is very good. I am using AWG18 cable. You can also look for MX brand speaker cables. Avoid very low priced cables which are normally found in Electronics stores. Some FMs are using finolex electric cables as speaker cables.
sarith
Active Member
Finolex..and v-guard is also good. It's a good idea to try and buy low gauge wire and use a pair of low gauge wires twisted to make a single wire (braided). I have used finolex 16-14awg for AC/DC wiring inside amps and 16awg for speaker use. MX is an economic choice.
Last edited:
prosenjit
New Member
get any branded like finolex,havvels..15-20 rs meter copper cable..
RajithKumar
Well-Known Member
Try Belkin or Bandridge brand copper wire (size 0.5 or 0.75 sqmm)..
Wharfedale Linton Heritage Speakers in Red Mahogany finish at a Special Offer Price. BUY now before the price increase.
