DIY Analog Interconnects using OCC Cable and ETI Research Copper Link RCA Terminal

[balavignesh002]

After the success of OCC speaker cable, wanted to try an analog Interconnect with the same cable as to get its signature on the analogue interconnect.

Have kept this 4 x 1 meter wires of OCC Cable on reserve.


Ordered set of 4 ETI Research Copper Link RCA and it reached last Friday, had a good time spending the weekend on making the cable.
very safe packing the seller has all gone green, didn't see any plastic


Crimped the source end of the cable and tinned it with Mundrof supreme solder.


Twisted the positive and negative pairs. And secured it with heat shrink.
Used some lubricant to push the cable in to heat shrink

Soldered them to the terminals




Fully finished Cables

 

[raj12345]

You are a True DIY enthusiast Hats off to you and your efforts.

 

[Nikhil]

Nice work! Those ETI Research RCA plugs look really nice.
What kind of OCC wire are you using?



.

 

[reignofchaos]

Very nice! Where did you buy the plugs from?

 

[balavignesh002]

You are a True DIY enthusiast Hats off to you and your efforts.

Thank you

Nice work

Thanks.

Those ETI Research RCA plugs look really nice.

Yes, they are light weight and rich looking.

What kind of OCC wire are you using?

This is the same OCC cable, what I have used for making speaker cable earlier

Very nice! Where did you buy the plugs from?

Thanks, Got it from Hificollective.co.uk