Whats this CNC Phonostage all about?

[Thad E Ginathom]

hey, you can also work with the following: a PCB, the components, an old razor blade for cleaning the component legs, a wife clipper

Is it anything like Bonsai? Keeping her in perfect shape but ...small? hyeah:

Even if I don't follow john_k_antony's good advice with the practice, but get someone else to do the soldering, I might well try one of these for my much under-used deck. Then there might be a MF V-LPS-II for sale! Don't advise holding of breath for that, though, and, anyway, I'd only sell it if the CNC was better

 

[sachu888]

Hi Thad,
You can ask Murli for audition of CNC.Sayed has built it for him.

Regards,
Sachin

 

[Thad E Ginathom]

Thanks... I was with Sayeed the other day. He mentioned that he did DIY jobs for others. Capt Rajesh also has another person who does soldering for him.

Murali introduced me to Sayeed at the HFV meet. Finally got to take some stuff to his workshop. He is really great

 

[sachu888]

He is a nice person with good experience.I never met him,but Chennai members hold high regards for him.

Regards,
Sachin

 

[john_k_antony]

wow!! I only hope its not too much for me

I am sorry if I really scared you . Actually its very very simple and LOTS of fun . As Sachin said, you will need some patience.

 

[AmitKumar]

Ok................I think I have to take the plunge

Sachin..please tell me once I order CNC what are you going to send me? And after I receive that what am I supposed to buy/source extra and how do I compile?

Hi Sachin,

For the knowledge of all the members it is good that you reply to above doubt raised by the Jay.

 

[sachu888]

Hi Sachin,

For the knowledge of all the members it is good that you reply to above doubt raised by the Jay.

Hi Amit everyone knows that.

Regards,
Sachin

 

[omishra]

Ok................I think I have to take the plunge

Sachin..please tell me once I order CNC what are you going to send me? And after I receive that what am I supposed to buy/source extra and how do I compile?

Jay, You should get PCB + all part (which will soldered on PCB). I think Sachin can provide LED + 10K resistance for indicator.

You need to get 4 X RCA connectors (chassis mount)
1 X banana plug for ground.
1 DPDT, 2A power switch
2 X 9V batteries with strip/wire connectors.
1 X 3 pin connecter for power
1 X box, MS preferred
4 X screws, spacers for PCB mounting
1 Ft Cat 5 flexible cable for wiring. Use individual strands.

See this for power battery connector
http://www.hifivision.com/phono-turntables/20115-batery-powered-diy-cnc-phono-stage-12.html post#118, 119

Whatever inside box, outside PCB will be covered by above list.