arnprasad
Well-Known Member
Also, I was shocked to see the way my engineer handled the Plasma.
He unmounted the plasma and turned it around 360 degree. I mean plasma must be kept straight, he rotated it with side port facing the floor
I asked him wont it impact the plasma, his answer was a small rotation does not impact.
In fact remember few days back when you were trying to register your product - I too had a look at the back of my Plasma to find the unique # and I notice dents on couple of places - again I dont think these dents happened during installation because such dents will not happens on a light touch. I think those dents happened at the Thailand factory before the back of the plasma was screwed into the unit - I was a bit surprised noticing it - but since its not causing me any problem, not sure if I should do anything about - nothing major - just a 1-2mm dent